FlexStream™ 微電腦滲透管氣體產生器
FlexStream™
微電腦滲透管氣體產生器
Gas Standards Generator
廠牌：KIN-TEK
供應商：志尚儀器股份有限公司
聯絡電話：02-22195511
| 快速詢價 |
行動條碼QR Code
•除了FlexStream ™ Base 之外，尚有五種模組可選擇。
•FlexStream ™ PM -Auxiliary Permeation Module
•FlexStream ™ GF/PM -Gas Feed Permeation Module
•FlexStream ™ SD -Secondary Dilution Module
•FlexStream ™ HG -Humidification Module
•FlexStream ™ IM -Interface Module
•
•流量範圍 : 250-5000cc/min
•流量控制 : 質流量流量控制器 (Mass Flow Controller)
•流量控制 ：≤± 1.5％讀數
•溫度控制 :電子式PID
•操作溫度 :可自行設定由20-150 ℃
•濃度範圍 : ppb -1000 ppm (依滲透管不同產生濃度亦不同)
•恆溫室容量 :
–1/4” 直徑SRT或是HRT拋棄式滲透管(最多可容8支)
–一支 LFH 或 ULED 可充填式滲透管
–最大外部長度6英吋
•滲透管種類 : SRT/HRT拋棄式滲透管/ LFH/ ULED具NIST Traceable報告
•High mass oven with electronic PID control
•Temperature Control Range: 5 ºC above ambient from 20 to 150 ºC (heat only)
•Temperature Setpoint Resolution: 0.01 ºC across control range
•Temperature Display Resolution: 0.01 ºC on front panel touch screen
•Standard Flow Range: 0.25-5.0 liter per minute
•Optional Flow Ranges: 0.1-0.5, 0.1-1.0, 0.5-10.0 lpm
•Flow Control over Calibrated Range: ≤ ±1.5 % of reading
•Flow Change - 0 to Full Scale: < 10 sec (2 time constants) at ambient pressure
•Mode Change - Zero at 1 lpm to Span at 1 lpm: < 5 sec (2 time constants) at ambient pressure
•Output Concentration Range: below 1 ppb to over 1000 ppm depending on emission rate and dilution flow rate
•Local Interface: color touch screen display with virtual keypad
•Remote Interfaces: RS-232 and Ethernet
•Communication Protocol: Modbus RTU
•Power Req: Standard: 115 VAC, 50/60Hz, 2 A
•Power Requirements: Optional (specified at time of purchase): 230 VAC, 50/60Hz, 1 A
•Dimensions: 6 inch Width x 13.5 inch Height x 20 inch Depth (add 3.5 inch to Depth for front panel inlet filter clearance)
•Weight: Approximately 30 lbs
產品關鍵字：
